7. How to connect a computer with K9 USB DAC function?

Windows computer]

1. Computer Installation Feiao DAC Universal Driver:Click

Attention:

a. this version of the driver can only be used in win10 and win11 systems, win7 and win8 are not applicable

B. If other versions of drivers have been installed, please disconnect all Feiao devices from the computer when installing 5.50 drivers (otherwise, a file missing prompt may appear after the 5.50 version is installed, as shown in the following figure)

2.K9 input setting: K9 [INPUT] switch to USB gear

3.K9 output setting: switch to the corresponding output port according to the interface used, the front panel is switched to [PO], and the rear panel is switched to [PRE] or [LO]]

4. Connect the computer and K9 through the square USB data cable, and set the audio output of the computer system and the audio output of the playing software to K9 for use.

5. with computer:play general lossless tracks as well as music in DSD format?Click to view

[MAC computer]]

MAC computer does not need to install the driver, choose to set the corresponding sound output device.

It is recommended to adjust the system volume to the maximum, and adjust the output volume of the unit by adjusting the potentiometer.

apple dac settings introduction:Click

Linux computer]

Linux system is drive-free and can be used directly in theory. However, due to the large number of versions, it is impossible to guarantee that all systems can be adapted. If connected, it is recommended to change to other data lines or USB ports for investigation, and it is not recognized that it should not be supported.

Views:0
Collection