7.How to use the K11 as a USB DAC for computer?

【Windows computer】

1. Install the FiiO DAC universal driver on the computer;

Driver download link: Click here

2. K11 input mode switch to USB;

3. K11 output setting: switch to the corresponding output port according to the interface used, switch the headphone or speaker output on the front panel to PO, and switch the line output on the rear panel to LO to decode the audio signal of the mobile phone.

4. Connect the computer and K11 through a Type C USB data cable, set the audio output of the computer system and the audio output of the playback software to K11 and then use it.

5. With a computer: How to play general lossless tracks and music in DSD format? Click to view

【MAC computer】

1. MAC computer does not need to install the driver, just change the sound output device to K11 after connection.

2. It is recommended to adjust the system volume to the maximum, and adjust the output volume of the machine by adjusting the potentiometer.

Apple computer DAC setting introduction: click

Notice:

1. When K11 is connected to Mac, it can play DSD tracks up to DSD128. This is because under OSX, the DoP can only support DSD128 (DSD256 needs to be packaged in 768K under MAC, and K11 supports up to 384kHz).

2. In theory, OSX can connect to K11 to play DSD256 through Native, but the corresponding playback software needs to pass through MFi and support Native output, such as Audirvana Plus, Amara Symphony.

【Linux computer】

The Linux system is driver-free. In theory, it can be used directly by connecting it directly. However, due to the large number of versions, it can not be guaranteed that all systems can be adapted. If it is connected, it is recommended to use another data cable or USB port to check. is not supported.